| Preparation |
PREVIOUSLY
PAINTED SURFACES:
In Good Condition: Wash down with Yacht Line Super Cleaner, rinse
with fresh water and allow to dry. Abrade with 280-320 grade (grit)
paper.
In Poor Condition: Remove all previous coatings and prime the
substrate.
PRIMING: All preparation for bare substrates is covered on the
appropriate primer datasheet.
BARE WOOD: Prime with Yacht Primer or UCP.
STEEL: Prime with Yacht Primer or Interprotect.
ALUMINIUM: Prime with Etch Primer followed by either Yacht Primer
or Interprotect.
GRP: Wash down with Yacht Line Super Cleaner, rinse with fresh
water and allow to dry. Abrade with 180-220 grade paper. No priming
necessary. - If any filling is required use the appropriate product from
the Interfill range. |
|
|
| Method |
Sand
the primer with 180-220 grade wet or dry paper. Remove dust with a dust
wipe. Apply 1-2 coats. |
|
|
| Hints |
Mixing Stir
well before use.
Thinner Thinners No.1 (YTA800)
Cleaner Thinners No.1 (YTA800)
Ventilation and Humidity Control Apply in dry, well
ventilated conditions.
Other For best results either stipple by brush or use a
mohair roller. |
|
|
| Some
Important Points |
Product
temperature should be minimum 10°C and maximum 30°C. Ambient
temperature should be minimum 5°C/40°F and maximum 35°C/95°F.
Substrate temperature should be minimum 5°C/40°F and maximum 35°C/95°F. |
|
|
| Compatibility/Substrates |
Suitable
for all substrates and filled surfaces. Not suitable for permanently
immersed surfaces. Do not clean with highly alkaline cleaners. |
|
|
| Number
of Coats |
1-2 |
|
|
| Coverage |
(Theoretical)
- 386.7 (ft²/Gal) |
|
|
| Recommended
DFT |
2.0
mils dry
|
| Recommended
WFT |
3.7
mils wet |
|
|
| Application
Methods |
Brush,
Roller |
|
Join Email List
